Rc helicopter>> WASP AUTO CP>> WASP AUTO CP one key switchover RTF

WASP AUTO CP one key Switchover Introduction Video:

Thank you for purchasing a SKYARTEC product WASP AUTO CP helicopter,which has advantages of high-performance,easy control,stable,durable,weight light. WASP AUTO CP helicopter,comes with 3-AXIS gyro system,tail rotor ,which can make sure to finish the 3D stunt flight easily. Moreover,equipped with 7ch LCD radio control and high performance N40 motor,WASP AUTO CP has better stability and agility.It is a good choice for beginners and experts.

STANDARD CONFIGURATION:

5 in 1 receiver board; 3.7V 240mah LI-PO battery; N40 brushed motor; tail motor; 2g servo(5 lines)x3; USB charger cable; USB power supply; special screw driver; 7CH LCD 2.4GHz  Radio control.

FEATURES:

The fuselage adopt strong,durable,special plastics

Hi-performance 3-axis flybarless system by SKYARTEC provides with much more stability,functionality and capability.

United design,outstanding stability and beauty.

High standard configura,you can perform kinds of flying skills.

Five in one receiver board integrating receiver,3-axis gyro,servo,main brushed esc,tail brushed esc

One key switchover,help beginner to accomplish acrobatic flight.

Specifications:

  Length: 225mm

  Height: 76mm

  Main Rotor Diameter: 240mm

  Tail Rotor Diameter: 36mm

  Motor Pinion Gear: 9T

  Main Drive Gear: 67T

  Flying Weight: 48g

Receiver adjustment:

    1. Receiver's indicator light status indicte:slowly flash means receiving signal,fast flash means the gyro is initializing,constant light means signal received,no lights on means no signal received.  

    2. Elevator/aileron sensitivity adjusting knob: clockwise, adjust to(+) direction,increase gyro sensitivity will add the balance effect of fushlage(fuselage no shake is the best);anticlockwise,adjust to (-) direction, reduce gyro sensitivity will decrease the balance effect of fuselage.

    3. Code-pairing: short press the button of the receiver,receiver start code-pairing ,the indicator light flash slow. Code-pairing succeed,the light will flash fast(when boot) or constant light(when work)

One key Switchover process:

  Switch: move Hold Up to the "on" position,move IDLE safely to the "0" position, move 3D gear to the "0" position

 1. please fly the helicopter to steady state first,keep with horizontal plane, the height is above 5 meters,the tail of helicopter is over against yourself,move the throttle to about 70%

 2. keep Idle safely at "1" position, then move 3D gear to the "1" position.

 3. the helicopter will 180° rotate clockwise at this time, at last rotate to the inverted flight state.