Daytime running lights controller manual
Main features:
An automatic switch lights: Microcomputer automatic lights when the engine is started, the lights turn off the engine for 15-20 seconds delay,
Experience to illuminate your home with stickers
(2) open automatically dimming headlights: After opening the headlights, daytime running lights brightness down 60%, to avoid the long-term in full
Set to work to extend LED life
3 synchronous flashing lights and turn strengthen a warning, so driving safer
4 strobe function: When the driver opened the security warning lights, daytime running lights into strobe state
5 built-in EMC circuit, to avoid interference with on-board computer system
6 applies voltage of 12V car, Waterproof IP67 standards

Operating Mode
Brightness time line engine work long bright lights, engine stop delay 20 seconds off the lights, turn on the headlights when: Mode 1
Down 60%, while turning lights stopped working the other modes, the corresponding side of the turn signal flashing lights follow
Mode 2-5: 4 kind Baoshan mode
Key Functions
Wireless Remote version: A key off key four kinds strobe mode switch B C D key to enter boot mode 1
Wired controller version: Each time you press the button to switch mode, press the shutdown, and then boot into the mode 1
Line installation
1 single line six, red positive, black wire connected to the battery positive and negative negative; White lines connected to the headlight dimmer positive;
Blue, brown line about turning around the turn signal control lines connected to the cathode; Yellow wire to ACC.
With specific reference to the control box on the back of the wiring diagram.
2 traces should avoid the heat of the place, take a good long after finishing the wiring harness and secured in the car.