Strega 2.9m wingspan rc glider model

DEscriptION：

RCRCM 2900mm F3F Glider – Strega

The Strega makes for an excellent F3F sport model. If looking for something that's fast and can maintain energy on it's turns, then Strega is for you!! The elliptical planform supports a very large speed envelope, with no nasty habits at low speed. The wing is two part, with a carbon joiner and a removable V-Tail. The wings and fuse are ready for your plug and play multiplex setup, allowing for super fast setups at the field or slope. The fit and finish of the Strega is similar to much more expensive models, yet it still has an industry leading level of pre-assembly!

Supported by a large carbon wing joiner, the plug-in wings are of elliptical plan form which has been optimized to give a compromise between good lift distribution without the attendant tip stalling behavior sometimes seen in truly elliptical plan forms. Fin and tailplane sections are also of advanced symmetrical design and have no drag bucket at any speed. Glider for experienced pilots, Strega offers outstanding performance and excellent thermal flight qualities. It is also able to pick up speed, to convince you. It is able to fly in virtually all conditions and it is equipped with ailerons, flaps and a motor. All surfaces are pre-painted in the molds for flawless external finish. The whole model uses live hinges and wipers for control surfaces. From its super-efficient V-Tail, to its new larger diameter nose area, this little guy was built for fun!

Special Features:

Control Surfaces: V-tail, Ailerons and FlapsTwo-piece hollow molded composite Full Carbon or Fiberglass wing designCarbon Fiber reinforced wing with square wing joinerLive hinges on the wing and rudder with pre-installed wipersSmooth, gel-coated finish with pre-painted graphicsFuselage hatch for V-tail servosGlider fiberglass or full carbon with a beautiful finish comes with all necessary accessories for mounting                                                                                       

Preferences                      motorless

wingspan:                         2880mm

length:                              1470mm

Flying Weight:                   N/A

Empty Weight:                  Fiberglass+Carbon Standard Version:1610g
Full Carbon Version: 1720g

CG：center of Gravity       102-110 mm from leading edge                                       

Servos for wings               KST DS125MG*4

Servos for fuselage           KST DS215MG*2

Required Battery               4.8-6V